Receiver Harness: Mamba Monster X 011-0106-00

About this part

Mamba Monster X Receiver Harness Connection Instructions To Remove the Receiver Harness: Place slight pressure with thumb on capacitor shroud (Figure 1). Grip the harness close to the 8 pin connector and pull gently, at a slight angle away from ESC, to remove the harness from the ESC pin header (Figure 2).

Note

• Do not yank or forcefully pull harness out of ESC. May cause damage to ESC or harness.
• To Replace the Receiver Harness: Place slight pressure with thumb on capacitor shroud (Figure 1).
• Following the color coded wiring diagram provided on the Monster X label, place the 8 pin connector onto the ESC pin header (Figure 3).

Note

• Misalignment of the harness will prevent the ESC from operating. Be sure that the brown wire is plugged in next to the negative (-) black power wire.
• Gently press on the 8 pin connector to fully engage with the ESC pin header.
• Reconnect cooling fan and receiver connections.

Fits