Incision Series 3 Light Kit

About this part

Designed specifically for the VS4-10 Phoenix, VS4-10 Origin Classic and its included molded front inner fenders (front and rear fenders for Origin Classic).

Features

• Molded front light buckets with high powered LED and heat sink Red LED tail lights White LED front/rear inner fender rock lights LED light controller Manual on / off function Additional on / off control from aux receiver channel.
• Headlights powered by 2-3S LiPo balance plug on light controller Aux control and red LED headlights powered by RX plug Package

You will receive

• X2 Molded front LED headlight housings with heat sink. direct fit / bolt pattern with Phoenix body grill X2 5mm red LED tail lights X4 PCB LED rock lights for use with Molded Inner Fenders (Use X4 on Origin, use X2 on Phoenix) X1 LED controller with required power plugs And a nifty parts box This item fits the following: VS4-10 Phoenix and Origin Body Sets Installation Instructions Remove stock light buckets from body set. Mount included light assembly to the body with the existing 1-64 hardware. Red LED tail lights mount into stock VS4-10 rear LED housings. Install Light controller to chassis and connect body mounted LED lights using 4 pin connector

Fits